Skip to content
English
  • There are no suggestions because the search field is empty.

Configurting Catadynes

What is Catadyne Configuration?

Catadyne configuration has one primary admin function: controlling whether operators can create new catadyne records from the offline site page at each plant. Beyond that, catadynes are self-managed by operators — they create units, log status, and create repair tasks without further admin involvement.

Key point: Catadynes at a plant or field location are always visible to operators regardless of this setting. The setting only controls whether the creation form appears at that location. If operators need to add a new catadyne unit, this setting must be enabled on the relevant plant.


Enabling the Catadyne Creation Form on a Plant

The catadyne creation form is controlled per plant via the plant settings page.

To enable it:

  1. Navigate to Admin → Plants and open the plant
  2. Go to the Plant Settings tab
  3. Find the Display Catadyne Creation Form checkbox
  4. Enable it and save

To disable it:

Follow the same steps and uncheck the setting.

What this controls:

  • When enabled — the "Add Catadyne" button is visible to operators on the plant and all its associated field locations (wells) when working offline
  • When disabled — operators can still view existing catadynes and log their status, but cannot create new catadyne records from the offline site page

Note on offline delivery: This setting is included in the sync payload. When an operator syncs, the app downloads the current value of this setting for each of their assigned plants. If you change this setting, operators must sync before the change takes effect on their device.


Catadyne Fields Reference

When operators create a catadyne, the following fields are available. This table is useful for training operators on what to capture at each site.

Field: Location on Site
Required: Yes
Notes: Free text — where the unit is physically located (e.g., "North Tank Battery")

Field: Size
Required: Yes
Notes: Picker: 6x6, 6x12, 12x12, 12x24, 12x48, 24x18, 24x24, 24x36, 24x48, 24x72

Field: Status
Required: Yes
Notes: Lit, Off, or Needs Repair

Field: Alias
Required: No
Notes: Short display name

Field: Fuel Type
Required: No
Notes: Type of fuel used

Field: Manufacturer
Required: No
Notes: Manufacturer name

Field: Model
Required: No
Notes: Model name/number

Field: Serial Number
Required: No
Notes: Serial number

Status and Repair Checkboxes

When a catadyne is logged with "Needs Repair" status, operators are prompted with the following repair item checkboxes:

  • Fuel Valve (Old)
  • Fuel Valve (New)
  • Thermo Couple — Aluminum
  • Thermo Couple — Copper
  • Regulator
  • New Catadyne Needed
  • Hand Tubed In
  • Thermostat
  • Clean Orifice

These checkboxes are recorded on the log entry and appear in the catadyne status report so the right parts can be staged before a service visit.


Catadyne Reporting

Catadyne reporting is handled in the Reports section. Two reports are available:

Catadyne Status Report — Shows all catadynes across the organisation with their current open log status, location, size, and a parts list if repairs are needed. This is the primary report for planning service visits.

Sites Without Catadynes — Lists all wells and plants that have no catadyne records. Use this toentify gaps in catadyne coverage.